Pro Liquid 5003

Surface Preparation

• The surface to be applied must be dry and clean; it must be freed from dust, dirt, rust, and oil, and loose parts must be scraped off.

• Sharp edges and areas prone to cracking, such as horizontal/vertical joint places, should be rounded by making chamfers using ProEdit 5045 repair mortar or chamfer tape.

• Large pores and cracks must be filled with ProEdit 5045 K repair mortar.

Application

• ProLiquid 5003 is applied only to the side of the application area that contacts water.

• It is ready to use and can be applied directly with a brush, roller, squeegee (gelberi), or unpressurized sprayers without requiring heating or thinning.

• Application must be done in at least two coats.

• To ensure strong adhesion, rid the surface of dust, and extend the lifespan of the application, ProPrimer 5002 must be used as a primer on non-metal surfaces, and ProLiquid 5003 on metal surfaces.

• Although ProPrimer 5002 dries in a short time like about 2 hours, in cases where multiple coats will be applied, one day must be waited between coats.

• In cases where higher pressure resistance is desired, it can be reinforced with carriers such as glass veil, felt, mesh, or isolation cloth to achieve a perfect result.

• On roofs that are continuously exposed to open weather conditions and are not walked on, an Aluminum pigment-additive is applied on top after the material is applied, providing protection from the sun and an aesthetic appearance.