Proflex Maxi 5060

Proflex Maxi 5060 Large Format Adhesive Technical & Application Guide

Technical Specifications

• General Information: $23^{\circ}\text{C}$ and %50 Relative Humidity.

• Appearance: Gray / White colored powder.

• Shelf Life: 12 months (in unopened packaging in a dry environment).

• Application Temperature: $(+5^{\circ}\text{C}) – (+35^{\circ}\text{C})$.

• Mixing Ratio: $6 – 7\text{ lt}$ water / $25\text{ kg}$ powder.

• Pot Life: 3 hours.

• Slip: $\leq 0.5\text{ mm}$.

• Open Waiting Time: $\geq 0.5\text{ N/mm}^2$ after at least 30 minutes.

• Service Taking Time: 24 hours.

• Consumption (Double-Sided): Average $3 – 5\text{ kg/m}^2$.

Surface Preparation

• Care must be taken to ensure that the application surface is solid, dry, load-bearing, dust-free, clean, and also level.

• The surface must be thoroughly cleaned from all kinds of oil, grease, rust, and paraffin residues, and there should be no loose particles on the surface.

• Defective surfaces with a depth of 5 to 20 mm must be repaired with modew Repair Mortar two days in advance.

• If the temperature of the surface to be applied is above $+25^{\circ}\text{C}$, the surface must be dampened.

• On gypsum-based surfaces, high-absorbency gypsum-cardboard, gypsum-plaster, aerated concrete, lime plaster, and chipboard, wallbond 5001 Primer is applied.

• Bonding can proceed 5 minutes after primer application.

• On PVC-based surfaces, the existing PVC coating must be firmly adhered to the ground.

• Any material reducing adhesion must be cleaned from the surface, and the surface should be roughened with sandpaper and primed with wallbond 5001 Primer.

• On metal surfaces, indoor metal surfaces (steel, aluminum, etc.) must be firmly fixed so that they do not move.

• The surface must be freed from adhesion-reducing substances such as rust, dirt, dust, and oil, and primed with wallbond 5001 Primer.

• For wood chip-based surfaces (OSB and Wood Chips), wood chip boards must contain a maximum of %10 moisture.

Application

• Care must be taken to ensure that the application surface is solid, dry, load-bearing, dust-free, clean, and also level.

• The surface must be thoroughly cleaned from all kinds of oil, grease, rust, and paraffin residues, and there should be no loose particles on the surface.

• Defective surfaces with a depth of 5 to 20 mm must be repaired with modew Repair Mortar two days in advance.

• If the temperature of the surface to be applied is above $+25^{\circ}\text{C}$, the surface must be dampened.

• On gypsum-based surfaces, high-absorbency gypsum-cardboard, gypsum-plaster, aerated concrete, lime plaster, and chipboard, wallbond 5001 Primer is applied.

• Bonding can proceed 5 minutes after primer application.

• On PVC-based surfaces, the existing PVC coating must be firmly adhered to the ground.

• Any material reducing adhesion must be cleaned from the surface, and the surface should be roughened with sandpaper and primed with wallbond 5001 Primer.

• On metal surfaces, indoor metal surfaces (steel, aluminum, etc.) must be firmly fixed so that they do not move.

• The surface must be freed from adhesion-reducing substances such as rust, dirt, dust, and oil, and primed with wallbond 5001 Primer.

• For wood chip-based surfaces (OSB and Wood Chips), wood chip boards must contain a maximum of %10 moisture.